For DeLi Linux 0.8.

• Put the CD-ROM in the drive
  • If you can't boot from the CD-ROM, create a boot floppy with the sbootmgr.dsk image you find in the isolinux/sbootmgr folder on the CD (read the README.TXT file, if you don't know how to do it; on some systems use RAWRITE12 instead of RAWRITE http://www.fdos.org/ripcord/rawrite/). Booting from this floppy will take you to a boot manager with a list of devices to boot from: one of the choices should be the CD-ROM.

• At the boot prompt
  • If you have a IDE system just hit ENTER
  • If you have a SCSI system type SCSI and hit ENTER

• If you have a brand-new hard disk or you wish to re-partition your drive type cfdisk, an example follows
  • cfdisk is an easy menu-driven partition program create new partitions with New
  • Create two primary partitions, a big one for the the file system and a small one for the swap partition
  • The size for swap depends on your amount of RAM. I suggest at least 64 MB
  • select the swap partition an select Type, then enter 82 (should be the default)
  • 
  • After you created the partitions select Write and Quit. It is highly recommended that you reboot the computer now to ensure that the new partitions will be recognized.

• Important: If you have lesser than 48 MB RAM you have to activate swap before installing, e. g.:

cfdisk                # Partition your hard drive
mkswap /dev/hda2      # if your swap drive is /dev/hda2
swapon /dev/hda2

• Type setup or deliinstall

• Select the appropriate keyboard for you, scroll down to the end end select OK

• Select a partition to use for your root partition and select OK

• Confirm that the partition can be formatted. All data on the partition will be lost.

• Select if you want to automatically scan for the CD-ROM or to enter the device manually

• deliinstall will now scan for the CD-ROM Make sure the CD-ROM is in the drive (it should be, unless you immediately removed it after you booted) and hit ENTER

• The DeLi Linux core packages will be installed now. You can watch the process by pressing ALT+F4. Press ALT-F1 to switch back. Setup will not switch back automatically when this phase is complete…Alt+F1 must be used.

• If you installed on a SCSI drive select Yes

• Confirm the swap partition

• If you, perhaps because of low RAM, already activated the swap partition by hand you should select No, otherwise Yes

• Select your language, scroll down and select OK

• deliinstall is now making device nodes (entrys in the /dev directory)

• You will now be asked for a password for root, the system administrator. Choose a password (a good one). Enter it again.

• After this you can add an unpriviledged user for daily work

• Enter the name of the user and type in the passsword twice

• For LILO installation select the simple method

• Just enter nothing when asked for kernel parameters

• I suggest you install in the MBR

Only for the full ISO:

• Now you can choose if you want to install additional software. The core package which was installed before is just very basic software with no graphical environment at all

• Note that a full installation will require about 750 MB hard disk space. Again, you can watch the process by pressing ALT+F4.

• After the packages are installed remove the CD-ROM (the disk, not the drive itself) and press CRTL+ALT+DEL to boot into your new DeLi Linux system

• Log in as root with the password you chose before. Now you can run delisetup to configure your system.